Scope of Delivery:
- 1x PFERD flap disc Ø40xH15mm grit size 120
Product Description:
Aluminium oxide A - with flaps made of abrasive on backing - for universal use from coarse to fine sanding - shaft Ø 6 mm
Technical Data:
- Shank Ø: 6mm
- Drive type: Straight grinder, flexible shaft drive
- Application recommendation: Use grinding oil suitable for the material to significantly increase the service life and grinding performance of the tools. For best performance, use at a recommended cutting speed of 15-20 m/s. This achieves an ideal compromise between stock removal rate, surface finish, temperature load on the workpiece and tool wear. Increasing the cutting speed results in a slightly finer surface finish. Increasing the contact pressure results in a slightly coarser surface. The softer the material to be machined, the coarser the surface (when using , An increase in the stock removal rate should be achieved by using a coarser grit size and not by increasing the contact pressure in order to prevent unnecessary tool wear and thermal stress on the workpiece. Reducing the contact pressure and peripheral speed and adding grinding oil reduces tool wear and the temperature load on the workpiece.
- Machinable materials: Malleable cast iron, steels up to 1,200 N/mm² ( 54 HRC, grey/spheroidal cast iron (GG/GJL, GGG/GJS), aluminium
- Machining tasks: Levelling, weld seam processing, surface processing, deburring, structuring (matting, line matting and satin finishing), fine grinding in stages
- Width: 15mm
- Note: PFERDERGONOMICS recommends flap discs in order to sustainably reduce the vibration and noise generated during use and to improve working comfort.
- Length, shaft: 40mm
- RPM, opt.: 9600RPM
- Safety instructions: For safety reasons, the specified maximum permissible speed must never be exceeded. The contact pressure must be significantly reduced if the specified optimum speed is exceeded. Safety is only guaranteed if the clamping length is at least 15 mm and the specified maximum speed is not exceeded with open shank lengths.
- Advantages: Consistently high material removal over the entire service life, as new, aggressive abrasive is constantly released. Optimum contour adaptation due to high flexibility. Can be used very close to edges and at angles thanks to the flat cast core design.
- Grit size: 120
- Max. speed: 19100 min-¹
- Abrasive: Aluminium oxide A
- Material suitability Aluminium: limited suitability
- Material suitability cast iron: very suitable
- Material suitability steel: very suitable
- Material: Aluminium oxide
- Ø: 40 mm
- Height: 15 mm
- Material suitability plastic: limited suitability
- Brand: PFERD For commercial use, please observe the building regulations!
For commercial use, please observe the building regulations!
