Scope of Delivery:
- 1x PFERD flap disc Ø15xH10mm grit size 120
Product Description:
Resin bond - universally applicable - also suitable for machining brass, copper and zinc - shank Ø 3 mm
Technical Data:
- Shank Ø: 3mm
- Drive type: Flexible shaft drive, straight grinder
- Application recommendation: Reducing the contact pressure and peripheral speed and adding grinding oil reduces tool wear and the temperature load on the workpiece. An increase in stock removal rate should be achieved by using a coarser grit and not by increasing the contact pressure in order to prevent unnecessary tool wear and thermal stress on the workpiece. Increasing the cutting speed results in a slightly finer surface finish. Increasing the contact pressure results in a slightly coarser surface. The softer the material to be machined, the coarser the surface (when using , For best performance, use at a recommended cutting speed of 15-20 m/s). This achieves an ideal compromise between stock removal rate, surface finish, temperature load on the workpiece and tool wear. Use a suitable grinding oil for the material to significantly increase the service life and grinding performance of the tools.
- Machinable materials: Copper, aluminium, malleable cast iron, brass, cast steel, hardened, tempered steels over 1,200 N/mm² ( 54 HRC
- Machining tasks: Structuring (matting, line matting and satin finishing), levelling, fine grinding in stages, deburring, surface processing, weld seam processing
- Width: 10mm
- Note: PFERDERGONOMICS recommends flap discs in order to sustainably reduce the vibration and noise generated during use and to improve working comfort.
- Length, shaft: 40mm
- RPM, opt.: 25000RPM
- Safety instructions: For safety reasons, the specified maximum permissible speed must never be exceeded. The contact pressure must be significantly reduced if the specified optimum speed is exceeded. Safety is only guaranteed if the clamping length is at least 15 mm and the specified maximum speed is not exceeded with open shank lengths.
- Advantages: Can be used very close to edges and at angles thanks to the flat casting core design. Consistently high material removal over the entire service life, as new, aggressive abrasive is constantly released. Optimum contour adaptation due to high flexibility.For commercial use, please observe the building regulations!
Read more less
Direkt ist günstiger für Dich!
